Generally, the inductance in the electronic circuit is an air-core coil, or a coil with a magnetic core, which can only pass a small current and withstand a lower voltage; and the power inductance also has an air-core coil and a magnetic core. The main feature is to use Thick wire wound, can withstand tens of amps, hundreds, thousands, or even tens of thousands of amps.
Power inductors are divided into two types with magnetic cover and without magnetic cover, mainly composed of magnetic core and copper wire. It mainly plays the role of filtering and oscillation in the circuit.
An integrated high-current inductor developed by Maixiang Technology, which can replace the magnetic toroid coil.
Its production process has been changed from the rail hydraulic type at the beginning to the slide hydraulic type. The product qualification rate has been controlled at 92%.
Chip power inductors, using powdered iron cores, offer better temperature stability and lower cost relative to other core options. The form factor of chip inductors provides flexibility and variability when necessary, but at a higher cost. High-flux magnetic rings are usually found in filter inductors rather than power conversion circuits. Another performance tradeoff can be seen in the typical waveforms of inductor current, inductor voltage (pin 14 to pin 16) and output voltage ripple. The use of the smaller inductance fdv0620-0.47μh inductor produces a higher peak current, and the output voltage ripple is lower than 18mv peak-to-peak.
The chip inductor produces a peak-to-peak ripple of just over 12mv. The peak current charges the output capacitor and supplies the load current. Larger current flows in and out of the capacitor, which results in higher output voltage ripple. SMD inductors are mostly used in power supply filter circuits. Inductors are energy storage components that focus on suppressing conductive interference; SMD inductors use a lot of inductive components and EMI filter components in the PCB circuit of electronic equipment. In the resonant circuit, the inductor must have high Q, narrow inductance deviation, and stable temperature coefficient in order to meet the requirements of narrow band and low frequency temperature drift of the resonant circuit. High-Q circuits have sharp resonance peaks.
